Review on πΊ Dernord Stainless Weldless Bulkhead Kettle: The Ultimate Brewing Solution by Chris Kidd
It does not seal in ball valves
The valve assembly is good but there are not enough sealing rings and there is only one washer. When the bulkhead is drilled to the recommended size, the o-ring will deform as it is forced halfway into the cavity between the valve threads and the edge of the bulkhead. I ended up buying a 1/8" thick silicone sheet and cutting my own flat gaskets. I also had to buy a 3/4" 304ss washer to match the one they sent so that there was even pressure on the gasket. This valve was reasonably priced, but when I add in the cost of replacement parts, it's not great.
- Lots of positive emotions
- New competitors have appeared
New products
Comments (0)
Top products in π§ Fittings
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
