Review on 🔴 Fusion Materials: Red PLA 3D Printer Filament - 1Kg Spool by Tim Hodzic

I have several printers that I print on a variety of materials: PLA, PETG, ABS, PC, PC-CF. Whenever I switched from high temp to low temp material I had (understandably) inconsistent extrusion and no clogging. I thought I would try this one. It works. Maintains similar extrusion properties from 190°C to 270°C. When I change filament type I run about a foot or so through the hot end at about 15-20C above the temperature of the last filament I ran. Pull out, skip the next thread until you get the right color and you're done. My only complaint? It comes in the form of a loose strand of thread. I'd happily pay another dollar or two to wind it up nicely on the spool.