Review on 🚙 MotoFab Lifts CH-2LM - 2" Front Leveling Lift Kit: Chevy/Gmc Pickup Compatible Solution by Danny Nedumaran

I bought this kit for a 2010 Chevrolet Tahoe LTZ 4WD. I found it interesting that they don't sell separate kits for 2WD and 4WD. The blocks themselves seem fine, one piece alloy. As others have said the picture is misleading as there are no emblems on the blocks. It doesn't matter much as no one will ever see them. The instructions themselves were ok, just text. no pictures. Installation is pretty quick until you get to the point where you need to insert a rear screw (locks in the cockpit). On GM 4WD vehicles, the shaft is directly above where you need to insert this bolt. There are a few fixes for that, the instructions say: remove shaft (yes, that's right). As with the others, you can install the bolts upside down with the nut on top (that's how the factory hardware is installed). The only problem is that the bolts were about 1/4" too long for my setup and they rubbed on the shaft. You can buy shorter bolts, or in my case I just cut off about 4 threads. As you can see. Based in the photos this gives you 2" of lift. It's not exactly flat on my car as the front is slightly higher than the back now but still better than the factory rakes.