Review on 🔎 ESUN 1.75mm 3D Printer Filament Spool - Optimize Your Search by Jhonathan Bagwell

When I needed to replace the fan shroud on my Prusa S3 printer, I could either print it out or order it. I chose to print but had to use the ASA thread. After reading about the ASA in general terms, I worried about being able to successfully print it. I chose eSun based on my previous positive experiences with their filaments. I was pleasantly surprised that with moderate precautions (higher temperatures and enclosure) it printed correctly on the first try. I printed on the eSun recommended hot side and the results were excellent. The spool doesn't hold line well and caused tangles until I used it a few turns, but that doesn't cost it any less stars.