Review on 🌟 EZ FAUX DECOR 36x72 Dishwasher Refrigerator Brushed Stainless Steel Film Door Panel Cover Nickel - Peel and Stick Convenience by Dave Albright

Based on other reviews this product will be difficult to work with but I really liked it. However, I could use an extra pair of hands during installation as the paper is difficult to hold while trying to peel off the backing while removing any air bubbles. The self-adhesive paper is thick enough to be peeled off and reapplied without creasing - just be careful not to crease/crease the paper as this will leave a line. I've peeled and re-glued a piece about 10 times because I couldn't get the edge up to the fridge line (my fault, not the paper). The trick is to start at the corner and fold the backing paper back a little. Swipe down the corner, then continue diagonally along the mount - while using one hand to peel more of the backing (slowly and 1 inch at a time), run your thumb across the entire diagonal area where the Adhesive protrudes / makes contact. It worked really well and I avoided a lot of air bubbles because I could see them and erase them over time. The tool that came with it didn't do much for me. but the clenched thumb did. I like how they turned out. The only hard part I had was the edges, which were slightly rounded - the paper didn't hold well initially. So I used a very hot hair dryer and then rubbed them to make them stick. After the fridge and dishwasher I had quite a bit of stainless steel paper left over and was looking for other things to cover because I liked the project. The cat will never be the same. :)