MotorGuide MGA089B Machete III 3-Blade Propeller - Trolling Motor Prop With 3.5In Hub, Pin & Nut Included Review

My original prop came off of my Motorguide 756 (Brute 56) the other day. Never had that happen before so I ordered this one in hopes it would fit. It DOES indeed fit it! I haven't had the chance to use it yet, but I am for certain ordering another one!

I bought the prop for a spare just in case I needed it. It was almost half the price if I would have went to the marina to buy one. It was shipped in just a few days. I bought it "used" but it was still in the original package.

It is winter still, so wont get to test this for a while. The build is good and it appears strong. Hoping it to be more efficient than the weed less I am running now.

It fit my minnkota 40 lb. Gives reverse a much better grip for slowing and maneuvering. Had to modify at the hub to fit. Just Fyi. Very minor diy.

It fits and looks good with the motor. Now, I just wish I got to use it a little more often. Workends vs. getting your line wet leaves a lot to be desired, but I'll still find a way to sneak off for a little R&R on the water.

Prop seems to push my boat better than the two bladed prop it replaced. I have one on my trolling motor and another one as a spare.

I purchased it to try to slow down my trolling motor. That didn't happen. What i found out was i have virtually no vibration. The most important part is my batteries last longer.

The MotorGuide Machette III propeller works nicely with the 70 pound thrust trolling motor on my pontoon boat. It is quiet so the boat can be moved easily and quietly into position using low speed settings. Some other propellers seem to cavitate and make more noise which can scare away any nearby fish.

when i installed it on my motor guide trolling motor, it vibrated very badly causing a lot of noise. sent it back for a refund

i have an old motorguide about 30 years old or longer. Havent used in 20 years. Recently , I have a use for it and broke the 4 fin prop. I saw this on amazon and bought it. BINGO! with slight modification (file) it fits and works as well or better than 4 blade prop. It is quite a bit bigger but no problems. Thank you.

Authentic part. I don't have thick weeds to worry about so I use the 3 blade prop.Chips and dings on the blades make more noise underwater. Keep your new blade nice and smooth.

After the first install I could tell this was not going to work on my Minn Kota Endura 30. But I wasn’t going to waste my time trying to send it back, so I broke out the dremel. After about an hour of cutting and sanding the plastic, it fits and runs without rubbing. Water test pending, so I’ll bring a couple of paddles.

Went from a bi blade a Tri blade because I fish mostly river made a tremendous difference for upstream fishing Thanks for attention.

It fits and seems to work well, but it's a little loose on my lower unit, no water gets in still and it does what it said it would do.

Comes with all the pins/nut so dont worry if you lost the old hardware. It works great. No vibrations like thr broke one had

Fit prefect gets me down stream. Lost nut second time now. They need to figure out better wat to attach to shaft That's my review.

The three blade machette prop had a noticeable difference in power and impressive weed cutting ability. Really enjoying the prop. every new motorguide comes with one now and for good reason.