Review on 🔧 Suspension Urethane Bushings by Carbhub: Enhancing Performance with High-Quality Bushings by Bobby Posner

I had a few issues with this product: The OD of the bushings was too large and I couldn't press them into the A-arm. I've tried all possibilities: c-clamp, pliers, arbor press, grease, etc. and the sleeve just shrunk. I know they're supposed to be tight, but they also have to fit. I'm guessing they were 1/16 inch larger. I ended up not using them and had to buy another solution. I was able to get the bushing into the bottom spring very well, but I had another problem. The "shoulder” of the jack turned out to be too big. With the hub in place and centered, the "shoulder" of the hub expanded 1/16" on each side, so much that I couldn't get the spindle yolk on it. I was able to remove enough of the excess material to make it a snug fit In the end I have no doubts the material is durable and well made but the size was my issue I recommend finding an OEM solution which I did for the A-Hand and it worked great.