Review on 🔝 Upgrade Your Chevy Silverado Badge with a Carbon Fiber 3D Emblem by Bishop Terry

"The very first thing you need to do is wipe the surface with a microfiber cloth soaked in alcohol." I couldn't find a "NO" instruction, but after careful research I am stumbled across the correct installation process. The assembled letters come with letters embedded in a foam frame with clear tape on top and clear tape on bottom. All you have to do is determine where you want to place the word (in this case SILVERADO) and then take into account that the bottom edge of the foam is 1/4 inch from the bottom of the letters. So figure out where to place the letters and place a horizontal piece of tape 1/4 inch from where the letters will end up. Finally turn the assembly over so you only see the back side of the letters (DO NOT REMOVE ANY PARTS OF THE ASSEMBLY UNTIL THIS STEP), remove the bottom piece of tape exposing the black tape, even align the assembly with masking tape and tape the assembly to the surface of the car, running your finger back and forth across the top piece of clear tape to ensure the letters are firmly attached to the surface. Then remove the tape and discard it. Last but not least, gently peel back the foam border starting at the right edge, carefully holding each letter and you're done. The letters are impressive. Instead of plain letters, get these letters on a clear strip and you'll be glad you did.