Review on 🚗 Walker Exhaust Ultra 53616 Direct Fit Catalytic Converter for EPA Compliance by Dan Tsourvakas

Just installed replacing an old block on my 2001 4Runner which had a rusted heat shield. Also uses a Walker Quiet SS muffler and Walker exhaust. All the spacers, hangers and walker bolts, but I didn't need all the rubber hangers as mine was still stiff and not cracking. I had to cut off the front studs with a jigsaw. The rubber hangers were very difficult to remove until I found a video of using channel locks and a little spray lube to loosen them from the racks. Seems to be well made and hopefully will last a long time. The connector for the O2 sensor was behind the coil where it was in the cat that came loose, it must have been a design change but there was still enough wire to fit.