Review on 36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer by David Romo
Perfect! Exactly what you want and hope will happen.
Note that your fan should have two screw holes on each corner, not one long screw hole. Usually you insert the long end into the screw hole, then grab the end and pull. As it stretches, the bump disappears. Do this with all four corners, then place the jar where you want it and pull the thicker short pieces through the body. The rubber rims form a good vibration barrier, and the whole thing acts like a rubber screw for extra dampening. Vibration.
- Pleasant
- Not the best
New products
Comments (0)
Top products in 🔩 Computer Screws
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Another interesting products
📦 Smraza Raspberry Pi 4 Model B Case with Fan, Acrylic Enclosure, 4 Coolers, 5V 3A USB-C Power Adapter, USB Card Reader, 6ft Micro HDMI Cable, and 7.8in Micro HDMI to HDMI Adapter Cable for 4K Ultra HD
9 Review
CZH-LABS Electronics-Salon Prototype Shield Kit for 🛠️ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review
Enhance Your Development Projects with the NVIDIA Jetson Nano Developer Kit (945-13450-0000-100)
12 Review
🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review