
Panel jacks must be cut with a dremel to accept 35-50 connectors from other manufacturers (larger lip on top). The bottom short lip is the seller (this item). I didn't show the female because it would be difficult to photograph the inside of the small hole, so the end of the male should have been visible. The man is doing a great job. There is less brass to brass, so the rating may be lower.

Inverter welding machine CET CET MMA 200A, MMA
23 Review

Continental Conti4x4Contact 265/60 R18 110H summer
23 Review

Hakko T18-BR02 Soldering Tip - T18 Series for Hakko FX-888/FX-8801 - Conical Shape - Bent 30 Degrees - R0.2 mm x 10.5 mm
12 Review

Hakko 599B 02 Wire Type Soldering Cleaner
11 Review