Review on 🔧 OEMTOOLS 27308 Ball Joint Separator: Adjustable from 1-1/8" to 2-1/8", Perfect for Common Ball Joint Sizes, Enhanced Steel Separator Mechanism with Black Oxide Pins by Andres Black

It takes a lot to impress me and this tool did it. I've always used a fork to separate the tie rods, knuckles, etc. because I was replacing the ball joint and didn't care about damaging the trunk. I had to separate the steering knuckle which already had an almost new ball joint. Wow, this tool did a great job. My advice, spin it until it's almost to the point where you think it might break, then wait a few seconds. Then maybe another 1/8 turn and boom, it's off. I've even used it on a tie rod that I'm replacing. It just makes the job so much easier. And pay $2 more than others so you can keep it in a suitcase and don't lose it in a bunch of other tools.