Review on 💨 Upgraded 95-125 PSI Air Compressor Pressure Switch with Unloader Valve by Jerry Delic

This is a direct replacement for the OEM source Lefoo. My old compressor started running intermittently and tapping that switch kept it running for a while. There are two differences to my original. The pressure solenoid on the side is straight and not at right angles so I had to reposition the valve to get it out. The original had strain relief on the power cords that went on each side, while this one only has protective shields. The cable to the motor doesn't need a strain relief like the power cord does, so I attached the cable to the bottom frame. With these changes, it worked immediately with ideal print settings. It took about an hour (I work slowly) and only required the usual hand tools. Teflon tape also works well for attaching this device. Remove the front panel (4 bolts on the corners) and the compressor (4 nuts underneath and unscrew the large hose) to gain access. WARNING: Resist the temptation to repot the new internal switch assembly into the old case! The switch assembly consists of two heavily spring loaded parts. I can't imagine how they even collect these things.