Review on 🔧 XtremepowerUS Composite Surface Sanding Grinder by Kevin Mariappan

Bought for grinding welds, spot welds and small parts in car restoration. I used it intensively and with almost constant load. Unit works well and comes with 2" and 3" squeegee holders on a 1/4" shaft. Purchased IIT abrasive discs on Amazon for use. Unit works well. for cleaning contact surfaces on any sealed surface etc Lubricate with 3-4 drops of air tool oil before and after use Unit works well at 90psi but consumes quite a bit of CFM with constant use Recommend this to anyone intending to use it for long term use UNLESS "Your compressor is at least 10 CFM at 90psi - otherwise you'll need to let the compressor catch up. Light intermittent use shouldn't be a problem. If you don't have a choice then this is a good pneumatic tool. I use a 3/8" OD -Line with 1/4" couplers and the unit works perfectly. Very convenient. IIT sells both scotch pads and a variety of 2" and 3" grit sanding pads. Very happy with the device and would buy it again.