Review on 🚙 MotoFab Lifts CH-2LM - 2" Front Leveling Lift Kit: Chevy/Gmc Pickup Compatible Solution by Demond Clenney

SATISFACTION. EXTREME SATISFACTION. I love my 2015 GMC Sierra Crew Cab too much to mess anything and didn't want to spend money on professionals, but I found out what the heck, 100% screw, requires no special tools other than a 15mm wrench. , and 2 sockets (18 mm and 15 mm). Let's start. First, the kit includes 2 aluminum standoffs, 4 bolts, 8 washers, 4 nuts and instructions. INSTALLATION TIP: For easy installation. I followed the YouTube video "Installing the 2010 Rough Country Leveling Kit" WHAT IT IS! However, there was a lot of pressure when trying to lift the stand and it looked like someone was going to get hurt. Didn't feel right. Well, after about an hour of trying to observe every moving part, taking a look and also trying to observe what's going on as well as "what's going to happen". WE FINALLY DISCOVERED THE PROBLEM. We found that the video instructions are missing a key step that can cause the installation to take anywhere from 1.5 hours to 20 minutes. GUARANTEED THAT'S OUR OPINION ONLY. But if you somehow managed to do it by watching the video in this post and following these steps, then you are most likely reading this because you broke something or messed something up and want to know how to make it easier it. In the video, they claimed to unscrew and loosen the anti-roll bar bolt. We were unable to move the post far enough away from the forearm to securely insert the brace. We simply unscrewed the top nut and completely removed it from the stabilizer bar, but left the screw in place. Gives you much more room to move the rack up and down. We then slightly removed the post from the wishbone, set the brace in place and rocked the bracket back and forth to line up the bolt holes. We used a small vertical hydraulic jack to rotate the lower control arm up so the stabilizer bolt protruded just enough for the nut to hook into. lever nut. Also, FYI, the other side took us 12 minutes TIME! Trust me, just remove the nut from the stabilizer completely. Now that we're done and have seen the bigger picture of what we had to do, I find this setup to be a very, very easy setup, probably a 2 or 3 on the 10th difficulty scale. I never post anything, but I figured out my two cents. can save someone an hour of daylight. PLEASE GIVE THE BALTS UP IF THIS REVIEW HELPED ANYTHING! Thank God. Update 4/9/2017: Since I first wrote this article I have installed this kit on several trucks and SUVs. Everything was easy and worked wonderfully! MOTOFAB is the way! Don't settle for less! Other brands have packaging issues, broken parts, missing parts, misaligned screws, long screws, wrongly threaded screws, unthreaded screws, etc. MotoFab has an unrivaled quality control department that ensures correct products with no defects.”