Review on Sabre Tools Scraper Adhesives SDS Plus by Chris Endricko

When I first tried tiling myself, I had to make a few mistakes. Because of these mistakes, I had to pull out some tiles that I hadn't prepared properly or apply a thin coat properly. Picking up the tile was easy, but I was left with the task of removing the hard thin set. Attaching to the SDS Plus Puncher in hammer-only mode made this easier. I was able to strip an entire tile from a thin layer in less than a minute. This blade is 4 inches wide, allowing for enough coverage in one pass. It was nice to see there was plenty of blue Loctite on the screws to keep them from accidentally loosening (I removed one to double check). The top used 8.8 grade screws so hopefully they will last a long time. I've used this on over 40 tiles so far and haven't had a single problem so far. Pros: - Blade diameter is 4 inches - All 3 screws are covered in Loctite - Overall length is 10 inches which keeps the punch closer to the body. - The blade is thick enough to prevent bending/warping. Cons: - not yet