I fixed my hoses with these. I recommend removing the old nozzles and cutting the old part of the hose before installing theses nozzles. I used a PVC cutter but a utility knife would work. Make sure to line the clamps up correctly.

Finally found these hose repair ends after the first two designs failed miserably. These are definitely good! The fittings may not withstand extreme temperature changes.

This makes all your junk hoses like new again. Cut off the old or crushed/stripped/stuck ends and clamp on these and you have a new hose again! Very happy with these, its an excellent value and I fixed all my hoses with one purchase and have a couple left over to spare! Excellent buy. Good quality clamps hold and extra rubber washers are provided also.

Nothing worse than a leaky hose but don't throw it away. This product solved the problem. Cut off the end screw on the connector and you're done.

I seldom write reviews, but this product was great! Like others, I'd tried several other repair components from my local (excellent) hardware store. Was not terribly optimistic, but thought this better than throwing out an expensive hose! Bottom line: went on easily, completely leak proof and only took 1-2 minutes to assemble. THIS IS WORTH IT!

I've got these tighted down as much as they'll go and it's still leaking so much, I hate to use it. I triple checked that I ordered the correct size for my hose, so that isn't the issue. It just doesn't tighten enough and I've waited too long to repair my hoses to return them. Don't make the same mistake.

Got a set of these to repair a couple of hoses that were damaged. Super easy to install, just shove the fitting in the end of the hose, tighten the screws on the clamp and you're done. Seems fairly sturdy and haven't had a problem with them yet.

This was better quality than the end that came on the hose, and saved me from buying a new one. I have other hoses that will get refurbished.

I purchased these to mend some 5/8" hoses based on the product description which says that these work for both 5/8" or 3/4" hoses. I tried them on several different 5/8" hoses (each a different brand) that I have which needed to be repaired and the 3/4" metal inserts I received with this product did *not* fit in any of the 5/8" hoses that I have.I had previously purchased some 5/8" hose repair parts that use a metal ring clamp but some of them were leaking regardless of how much I tightened the

I had a tear in my hose from bending it to stop the water flow. I didn't want to throw the whole hose away so I tried these. They worked great! I just cut the hose to remove the section with a tear, and I connected these on either end. It took 5 minutes, and all I needed was a screwdriver. It holds the water pressure with no leaks when I have a nozzle on the hose. I'm very satisfied.

This method of securing a male or female end on a hose is far more secure, and less likely to leak than any other method I’ve tried including the round metal screw adjustable clamps!

I had 2 hoses to repair. On my black rubber heavy duty hose this worked fantastic and had no issues. When repairing my green medium duty hose the fitting was not get snug enough. I wrapped the end of the hose in a few layers of electric tape to make the hose wider and was able to tighten it down so it would not leak, so far that has done the job, but I suspect it is not a long term solution. It be nice if it came with sleeves to accommodate smaller diameter hoses. Regardless, this beats out…