It’s a nice product, super simple to use.Not a fan of the metal zip ties that came with the wrap, they are junk and don’t keep tight; Better off using screw clamps to insure the wrap stays tight and in place. Over all satisfied. Also have plenty footage left over so I can wrap the exhaust manifold on my truck

Installed on Dodge 3.9L factory exhaust manifolds, in lieu of factory heat shields/deflectors. Tape/material functions well. Time will tell, if the small, what looks like stainless, ties hold.

I purchased this wrap for my VW classic beetle. The aftermarket exhaust was adding excessive heat to my engine compartment. The wrap did the job. I just dumped the wrap in a bowl of water and wrapped it with one end in the bowl. Highly recommend keeping it wet. This will keep the fibers from flying into the air as you wrap. Keep your skin covered. Safety goggles are a must. As soon as i was finished with the install, I vacuumed the entire area and my clothing. Some did make its way through my…

I had to wrap a muffler and exhaust pipes on my 56 T'Bird for 1) shielding B&M transmission shift cable from heat and 2) reduce radiant heat into interior of car. This accomplished both. The ties are okay for small exhaust pipes. They due give a little bit after snugging them up, so they do not work as well plastic ties (not usable for high temp). I bought 11" ties and had to link two together to surround muffler.As a work around for inability of tightening ties real snug, I put a dab of…

This looks awesome on my motorcycle and helps keep heat of my leg and able to ride with shorts now, I like that it came with metal zip ties and gloves because you dont want to touch this barehanded no bueno lol I honestly didn't use the zip ties since hoes clamps work better and tighten better to hold at the ends but also recommend to soak in water for about 5

The Green Egg lid fell on my brand new $48 Big Green loop lighter. (I went through three Looftlighters in 7 years…no more!). The plastic handle was shattered, so I bought this heat wrap and just made an ugly handle over the broken plastic one. It work. Ugly, but works. When this unravels, There’s 40 feet left to make another.

Just received this earlier today and installed it on a complete system. When wrapped with the stainless adhesive tape and clamped with the stainless ties I purchased from Walmart then coated with the silicone insulating spray the exterior exhaust surface temperature averaged 20 degrees cooler than the previous products I utilized. The turbo spools quicker and the waste gate opens sooner resulting in reduced lag. The precats light off about 20% sooner and their internal temps are at the upper…

Works nicely if you can get on tight and secure both end. Ended up using Stainless steel wire to secure it. Should work better if whatever your wrapping is sitting on your work bench.