🌊 A13052700Ux0176 2 20 Gallons Per Minute Flowmeter Measurement Diameter Review

later Good product but it's very difficult to seal the pipe threads. Don't over tighten as the plastic is very brittle and I cracked it. That's not possible if you have a spare part you will need to buy a new one. Be sure to use liquid teflon in combination with teflon tape to achieve a good seal of the joint.

I have 2 of these - a ground source heat pump system that meters the flow of water from a well. There were no issues with leaks as others have said. They are very accurate when tested with a 5 gallon bucket and a stopwatch. However, after about a month both had a metal float stuck in the up position, rendering them unusable.

I bought 4 of these and 3 of them have expired. I wasn't able to seal two of them without breaking one of the hubs. The third simply broke and after a month of operation began to leak when water with a temperature not exceeding 80 degrees flowed through it. The fourth is currently sealed, but I'll keep a close eye on leaks in the future. To sum it up, save your money and look elsewhere for something with metal hubs that can handle tightening the appropriate metal fitting. I've added a photo of…