🔧 NICECNC Blue 4CM/1.57inch Rear Shock Absorber Lowering Suspension Drop Links Lower Kit - Compatible with Suzuki DRZ400/E/S/SM 2000-2021, Kawasaki KLX400 2000-2019 Review

I lowered my 2020 Suzuki DRZ400 SM so I could touch the ground. Looks nice to match my gold rims It has intermediate bushings on both ends. Happy with them!

They are advertised with a 1.57" drop, but my DRZ400S dropped 2.25". The side stand doesn't work, the bike is so low. Rolled and the wheel hit the bottom of the bike. Not good. No blank, these are cast.

Too low and the damper was soft. Stock removed and installed. You just have to accept that the bike is high. Put in a Suzuki gel seat, which lowers the seat 1 inch but is less comfortable. 30" inseam so not too bad, but it sucks in the woods.

Good fit and finish. I appreciate the zinc plated steel bushings where the bolts go. After installing these links, I re-measured the seat's center point above the floor and found that it was now 0.8 inches lower than before. Your results may vary but are lower by definition.

Be sure to check the height of the lowering. Somehow I ordered 7cm for the first time. The seller returned the money with no problems. I got and installed 4cm links that actually reduced the static sag by 1" which is just right for me. Even lowering the raised front/rear forks is enough to eliminate jerky handling at high highway speeds.

A quality part that really gets the bike going. I'm 5ft 6" and on my feet with boots on the DRZ400S. As you can see in the picture, the gap between the muffler and the tire has decreased slightly compared to the original height. The first time I rode a rut I hit the bottom, so it's intended for lighter and less aggressive riders. I weigh 190.

Very well made and looks like a good powder coat finish gives these links a nice look. According to some links available on the Internet, the sockets are not installed and are exposed. These links are pre-pressed and aligned to ensure a perfect fit. Good product. I would recommend these links. Delivery was fast, product was well packaged. I would do business with this company again.

Fits perfectly, went in easily. Was tiptoeing and felt a bit uncomfortable at stick height. Put those dog bones up, no, I'm about an inch from the apartment. I didn't want flat, I wanted my footpads to be firm and stable to provide a solid base for balance. They fit my drz400 perfectly. Also adjust the shock preload a bit and tighten the shock setting. Mine was lowered 1 1/16 inches to match. I rode and the bike is much more stable for me, much more manoeuvrable and I'm very happy. Feel a lot…

On a 2 week old DRZ400 (OEM height 36.8 on seat) I couldn't do more after the front dropped 9/16". 34.75" before the fronts fall off. And after adding the 30mm shims. Without the shims you can only lower the handlebars about 3/8". I'm 5'10" with a 31" inseam and couldn't balance the bike vertically at the OEM height; it bent towards my toes a bit and it didn't work for me because I was afraid my calves would one day curl up and I would fall. From center to center this joint is about 140mm long;