🔧 ACDelco 214-2317 Vapor Canister Purge Valve - Genuine GM Original Equipment Review

Easier to install than a headlight. I watched a 5 minute YouTube video, removed the old one and pasted the new one. The part is identical to the one already in my car (thanks to Revain Garage). Autotire offered me over $400 for this code and repair.

replaced the flush valve on a 2012 Cruze. This cleared several OBD2 codes (P0171, P015B, P2270), actually all of them. Also fixed the Service Stabili Track warning on the dashboard. A simple and inexpensive fix that took about 5 minutes and a screwdriver.

I am not sure why the manufacturer on the box is different than the manufacturer on the product itself but I can say I am completely satisfied. It fitted my 2015 Chevy Cruze perfectly and the check engine light went out as soon as it was installed. This took me about 5 seconds.

This item was a direct replacement for a factory defective Chevy purge valve that was giving us a 'Check Engine' reading. The swap was a big issue, but it had to do with the placement of the car, not the product. Much cheaper than the factory product and has been working flawlessly for over a year. highlighted.

Our 2011 Chevy Cruze LS 1.8L had problems starting after filling the gas tank. I've read that this is the part that needs to be replaced when this happens. This is an exact genuine manufacturer part made by Bosch and distributed by AC Delco for people who don't understand why the Bosch part is in the AC Delco packaging. This is the same part that originally came with the car. The replacement took about 3 minutes if you know how to remove the clips on the PCV valve. After the replacement there…

A few months ago my 'Check Engine' light came on but I had no symptoms. He gave me a code that something was wrong with my vaporizer system. A few months went by and suddenly after filling up my 2015 Chevy Sonic was incredibly difficult to start and also very rough at idle. I did a little research and was 95% sure this was the part that went bad. It turned out to be so! Normally, when you remove this valve, you should not blow through it. If you blow on one end and the air comes through, this…

I have a 2014 Chevy Sonic and every time I fill up with fuel it starts hard and takes a few tries before it will start. I stumbled across the code for outliers, did a bit of research and found a video of "Mechanic Link" on TikTok that this part might be the cause. He said if you can blow air through it that's bad and I made sure I couldn't with this new part and after removing the old part I checked and was able to blow air through. I drove to the gas station and filled the tank and it started…

My wife's 2016 Chevy Cruze had trouble starting after filling up. If the car starts, everything is fine. A problem occurred after opening the tank cap. After some reading I came to the conclusion that we need this part to diagnose the problem. INSTALLATION: The part on my wife's car is located just behind the engine at the top of the passenger side of the engine bay. The installation took no more than 5 minutes. Disconnect a wire connection and two vacuum ports and you can remove the part from…