Header banner
Revain logoHome Page
πŸ”§ precision adjustable reamers with h4 h14 blades - 515 adj11 logo

πŸ”§ Precision Adjustable Reamers with H4 H14 Blades - 515 ADJ11 Review

3

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
πŸ”© Reamers Tools, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”§ Precision Adjustable Reamers with H4 H14 Blades - 515 ADJ11
img 2 attached to πŸ”§ Precision Adjustable Reamers with H4 H14 Blades - 515 ADJ11
img 3 attached to πŸ”§ Precision Adjustable Reamers with H4 H14 Blades - 515 ADJ11
img 4 attached to πŸ”§ Precision Adjustable Reamers with H4 H14 Blades - 515 ADJ11

Description of πŸ”§ Precision Adjustable Reamers with H4 H14 Blades - 515 ADJ11

11pcs/set Adjustable Hand Reamers A-K, 15/32" to 1-1/2", HSS 6 blades #515-ADJ11.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 5 out of 5

Excellent value drill set

I was a bit skeptical at first but today I used them on my lathe to ream a shaft to press in a bearing. They work great. Be careful with the micrometer: they are sharp and can scratch the measuring surface. I will use them a lot.

Pros
  • Industrial & Scientific
Cons
  • No power

Revainrating 2 out of 5

The necks are not heat treated or even hardened.

I don't like this set of reamers as they are made of very soft steel and have coarse washers. Great care must be taken not to twist small diameter stems. It's more like a high school class than something you'll be proud to have in your hardware store.

Pros
  • Cutting Tools
Cons
  • Not sure

Revainrating 3 out of 5

Beveled blades in reamers

Rings for positioning or holding blades too soft. The rings were dented when shipped, I don't know if too much force was used from the factory, but this makes it difficult to set the diameter when the rings are rotated, they hang on the blades. The wooden floor of the fuselage broke in the corner. I also found, as per other reviews, the taper along the length of the blades rather than just the beginning end. I made a 22mm hole that was supposed to be 2" deep, the taper of the blades made it…

Pros
  • Reamers
Cons
  • old