Enhanced Full Motion TV Wall Mount: Adjustable Swivel and Tilt Bracket, VESA 75x75/100x100/200x100/200x200, Compatible with Sanyo LCD LED 19-32 inches (DP19640/DP26640/DP26670/DP32640/DP32670) Review

I had no trouble hanging this stand and installing a TV on it. However, the stance isn't as flexible as it could be, but it worked in the end.

I mounted a very light 24 inch television on this bracket. Went on smoothly. The screws that came with the mount were too long for the TV, luckily there were already short screws in the sockets on the TV.

Works but the screws provided are very cheap and VERY easy to remove. After sanding them into my wall I removed them and used my own bolts and screws. The instructions are also missing.

Bought this for my husband to hang his TV on the gym wall. It has a 26" Sanyo flat screen. The TV was hung on the wall in 15 minutes. This mount was very easy to install and held the TV to the wall very securely.

I couldn't expect more than I got. Products with the same functionality available on the market cost over $80 which is completely insane and this one does the job well! I don't regret my purchase one bit. Act! Although the installation guide could be improved.

When I purchased an adjustable VESA Full Motion Swivel Tilt TV Wall Mount to mount my Vizio 19" LCD/LED TV on a basement wall, I was a bit skeptical of the advertised claims. But the simplicity and flexibility of this wall mount is amazing. it works better than i can imagine!

This thing is TERRIBLE! 1) The screws are all odd sized. I had to rummage through my entire tool box to find the right size and it still didn't fit properly. 2) All the screws must be tightened before you even hang it on the wall, otherwise it will swing like a flag in the wind. .3) The screw that controls the up and down motion CANNOT be tightened enough to prevent tipping. 4) Extreme lack of instructions. At least they could tell me what size drill bit to drill holes for the wall anchors. I…

Good design, good product, but needs improvement. It took some effort to install and hold the TV in the lowest position once installed. The TV seemed to keep tilting forward as if looking at the floor. If you try to tighten the screw that holds the corners in a mutual position, the corners will begin to move towards the center with difficulty, while the metal can be forged. A brass copper rod to add strength to the block would be a nice addition. However, a unique unit to be so close to the…