🔥 AIEVE BBQ Utensil Holder Grill Hanger Hooks - Heavy Duty, 2 Pack Grill Hooks for Utensils, Organizer for Char Broil Gear Trax System - Ideal for Hanging Grilling and Cooking Utensils, Outdoor Barbecue Tools Review

Two polished stainless steel frames (not shown in listing) come with mounting hardware and fit my Char Broil gas grill. All I needed for installation was a Phillips screwdriver. They look good and are durable so I now have a place to hang my dishes while I cook. Conclusion: recommended.

Chrome plated well, easy to install on my Gear Trax pre-drilled char-broil, but SUS304 stamped on front ruins the look badly. See picture of what I installed on the right side of my grill. I would not buy this product again because of the stamp.

Item arrived quickly, all parts in good condition. Fits perfectly on my Charbroil Grill with Gear Trax holes. I actually ordered another set so I can have 6 hooks on each side of my grill. Very happy with the fit and finish. There are a few tiny nylon washers in the hardware bag. It's easy to miss. They come from the side of the wing nut.

Wing nuts make them very easy to install. They look great on my grill and are 100% more durable than the plastic parts Char Broil sells. A word of caution: spread a towel under the trellis when you set them up, this will prevent them from falling all over your deck if you drop a prop (they're pretty small). I think it's a metric stainless steel mini screw so a little hard to find at hardware stores.

This is exactly what I wanted for my Char Broil Grill. The holes are perfectly placed so it was very easy to install. I was looking to fit 2 on a side table and yes they both fit. Unfortunately, one arrived bent about half an inch. I contacted the manufacturer and they requested a photo which I sent. I haven't heard a word from them again. Bad customer service. I have a good one at this price which makes it quite expensive. If you can get the ones that aren't defective, they're great. You just…

This product was just what I needed to add hooks to my grilling accessories. I removed the grill wings (shelves) from my grill and carefully aligned them. - Connect the hook to the top of the shelf. My shelves were thin sheet metal so I placed some wood under the shelf to support it while I used a hammer and center punch to poke a hole in the hole (to keep the bit from wandering). I attached one end of the hook with stainless steel bolts, nuts and washers and adjusted it so it was parallel to…

These are great and well finished items in solid polished stainless steel to match the photos. You get two sets of three hooks per pack, plus screws and wing nuts to hand tighten. I have these for my new Weber Spirit Stainless which is a great grill but only comes with two stupid chrome plastic hooks, whatever. First I swapped the two side tables on the grate so that the factory plastic hooks were on the left at the back. Then I carefully drilled two holes in the front of each side table (I…