🔧 All Balls Racing U-Joint for Polaris ATP 330 4x4 04 - High-Performance Front Axle-Inner U-Joint, Compatible & Reliable Replacement - 19-1005 Review

My 2012 Athlet 400 absolutely couldn't fit in the 4th clip as did my mechanic with 20+ years experience and he used a press BUT the original factory settings that I removed were just that she also 3 clips.

I had no problem replacing the driveshaft on my 15 year old rear driveshaft, it was so swollen I replaced the forks as well. They appear to be of good quality, no assembly issues and the oiler makes them better than OEM in my opinion. It wasn't difficult to use my store press, if you don't have a press save yourself the headache and press it for yourself.

Part #19-1005 will work on a 2000 Polaris Xpedition 425 rear drive shaft, although Revain claims it doesn't. That being said, this part number will likely fit the front drive shaft as well. Very happy with the quality, I would definitely recommend adding extra grease to the covers during assembly to avoid the needle bearings falling out during assembly and cracking the cover and/or completely destroying the gimbal.

I bought these to fix my Polaris 700. Two covers broke during installation so I bought a replacement at an auto parts store. Caps splinter and break. I had it expertly installed at the shop, which resulted in all sorts of colorful words from the mechanic when I went back to pick up the driveshaft.

These things are terrible. Me and my friend have the same RZRs, we ordered 6 of them in total (3 per car) and 2 of them were bad and need to be returned. The needles are a lot smaller than the factory joint and a lot smaller than the NAPA/SKF bearing we ended up fitting which looks like a really high quality part even though it's made in China but can also be lubricated. and I hope it gets better than this crap.