💡 ALOPEE 30-Pack Warm White LED Bulbs: 194, T10, 168, 921, 2825, W5W - Car Interior Dome, Map, Door & License Plate Lights - 5SMD 5050 Chips - DC 12V Review

Works great in my RV lights on wheels. I have attached a photo. Super installation, just paste! However, I've noticed that they only turn on when you're looking in a certain direction. To test this, simply turn off the light, plug in the bulb, and turn the light back on. If the bulb lights up, it's in the right position, if not, just twist the bulb and put it back in place. I love the warm glow of this bulb, I'm not a fan of the blue/white light some bulbs give off. This bulb isn't very bright,

They are an excellent replacement for the 168/194/2825 bulbs in the 2 cars I have used them in. The dome lights seem to work well as the car doesn't normally start and charge when the doors are opened. However if you use them for parking lights (parking lights, license plate lights) they will take 3-6 months to burn out as the vehicle charges 14.4v which is above the listed 13v. I've driven at least 8 and don't drive a lot at night. Luckily they're cheap, way cheaper than bulbs in dealerships…

I decided to upgrade my incandescent bulbs to LEDs, partly because I'm a geek and think it looks cool, but also because my kids sometimes turn on the lights and forget to turn them on. And the problem with a dead battery is not cute. I originally had "Daylight" (6500K) blue tinted LEDs and while they looked pretty slick when first installed, they were too bright at night. Maybe I'm getting old, but they caused me night blindness (when I get a spot in my field of vision after looking into the…

First picture with old bulbs (5w each) Second picture with these LEDs (0.8w) Third picture a few meters away and they are just as bright if not brighter than the old ones. They can be found in the semi and work great replacing interior domes and dash taillights for lamp 194. I bought them for two reasons: 1. To reduce power consumption when the lights are on (16 in dash and another 12 in the cab) . 140W in total. Once installed, they consume less than 23W), especially to reduce the drain on my…

I used them to replace 194 bulbs in the Trailblazer and Envoy XL. The physical size of the lamp makes it difficult to install and cannot be used directly in some applications. It looks like the base where the pins are located is wider than the original bulbs. I didn't have a caliper to check the actual width. The size of the lamp itself is too large for some applications and does not allow the use of some original equipment such as B. Reflectors for map lights. They are lighter than normal…