Aluminum Alloy G1/4 LCD Display Flow Thermometer With Digital Temperature Indicator - Silver DIYhz CPU Temperature Monitor Review

Bought for my custom loop. Attached at a 45° angle. No leaks, and water doesn't come into contact with aluminum. Display is easily read from my chair about five feet away. Power hookup is Molex. The three-pin connector absolutely works to provide power (despite my assumption that the logic is 5V, and the fan header providing 12V, it works fine. The 4-pin Molex connector is not needed in this case). I assumed it to be a tach report for flow, but my motherboard can't get any reading off of it…

It's great with the exception of a rattle from the internal parts. Still works as intended and I can't hear it unless my side panel is open.A standard plug and better plug position would be better also since the little plug that goes into the unit feels pretty delicate and comes out the bottom. Be better if it was located on the back so you can more easily cable manage it.*UPDATE*Caused corrosion in my loop. All traces go back to this Flow meter.

Value for money, showed flow meter and right degree. Compare to Thermostat or Bitspower, it cheaper than and save money on your pocket

This is a great little flow and temp meter. Sturdy aluminum outside. No cheap parts. There are clear instructions on how to reverse the flow in the item pictures. If you can't figure that out, you probably shouldn't be water cooling your computer.