🔪 Enhance Precision and Flatness with Amana Tool's Spoilboard Surfacing Flycutting Review

Great for removing LOTS of material, with large tolerances in cutting width and depth of cut, quickly. But a word of warning: be prepared for MUCH more dust in the air around the CNC machine if you don't have a high CFM dust collector. My original spoilerboard planer has 2 blades and is 2.5 inches wide and I don't have much of a problem picking up dust. But the same requires about a third more passes. large square corner pockets.... the knives mill a 45 degree angle that must be removed with an

I have been designing and designing hardwood, composites (MDF, LDF, plywood) and other materials for more than 10 years. I used to use standard knives, so-called planing knives (e.g. Magnate 2708), which leave milling marks, burn marks and even cracks where the wood fiber tufts are pulled out and exposed. 2259 I used Amana RC-2258. The 2258 worked very well most of the time, but burned occasionally (not often) when planing hard maple and no matter what feed rates and speed/RPM changes I tried…

Received this bit today and I can honestly say it's a monster! The problem is that 4 out of 5 carbide inserts were chipped. Only one was perfect. I'm leaving a bad review at this point because for the almost $200 I spent I was expecting 5 flawless deployments. If they send me new inserts without any problems, I will update the review. I have attached a picture of each insert. *UPDATE* I contacted Amana and they offered to send me new inserts for free, so I'm changing my rating to 4 stars for…