🚿 Enhance Your Bathroom with the American Standard 022650-0020A Diverter Tub Spout in Polished Chrome Review

Easy replacement of the original tub faucet. In fact, this is an exact replacement after almost 20 years. Looks great and works.

$8 in stock trades. It doesn't scratch and works great! Our previous spout buzzed and squeaked the entire time you showered. Not anymore, fresh print!

Installs on 0.5" straight copper tubing. Easy to install and looks great. I recommend using the chrome bezel (shown in picture) with it.

Exactly what I was looking for to replace a leaking spray spout with my standard American faucet! I went back to the shower with full pressure, it didn't even drip out of the spout while showering.

The old spout was also replaced because hard water makes the trigger stop working. Installed a new spout and it's amazing how much more pressure you get when water isn't flowing out of the spout into the drain!

I bought the cheapest Danco replacement I could find. It was a mistake, ended up spewing water back into the wall, worse than the old one I replaced. The American standard tub spout worked much better. Just slip on the existing copper pipe and all I had to do was tighten it up.

Replaces an old and leaking diverter tube. Installation was easy and looks good. It seems a little more expensive than it should be, but then again, everything is expensive these days! Just make sure you need a spout and that you've sanded down any sharp edges on the pipe before attaching it.

This American Standard elbow is exactly as ordered. Visually, it comes very close to the original part that was intended for replacement. And the American Standard diverter I ended up using, a duplicate of it but not the "patch on" type, actually works better than the original (hardly drips when using the shower). It only took 5-10 minutes to install, which I'm incredibly happy about.