Header banner
Revain logoHome Page
amt pump 5381-95 immersion coolant pump, cast iron, 0.125 hp, three-phase, 230/460v, curve-a, 0.375 inch logo

AMT Pump 5381-95 Immersion Coolant Pump, Cast Iron, 0.125 HP, Three-Phase, 230/460V, Curve-A, 0.375 Inch Review

4

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🌊 Water Pumps, Parts & Accessories, 🚰 Rough Plumbing

View on AmazonView on ЯM

Media

(1)
img 1 attached to AMT Pump 5381-95 Immersion Coolant Pump, Cast Iron, 0.125 HP, Three-Phase, 230/460V, Curve-A, 0.375 Inch

Description of AMT Pump 5381-95 Immersion Coolant Pump, Cast Iron, 0.125 HP, Three-Phase, 230/460V, Curve-A, 0.375 Inch

Replacement oil and coolant pump for use with machine tools. Semi-open impeller handles solids and fine contaminants. Cast iron with stainless steel impeller and sealless design. Pumps fluid levels as shallow as 2". Sealless design for pumping abrasives.

Reviews

Global ratings 4
  • 5
    2
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Superb pump Best of water pumps, parts and accessories

Quiet, inexpensive, well built. Just wrong labeling of wires, a cover, it's clear which wires go where. I am very happy with the pump.

Pros
  • Cast iron with stainless steel impeller and sealless design
Cons
  • Almost never

Revainrating 3 out of 5

Mislabeled wiring fits water pumps, parts and accessories

Fits my Arca bandsaw exactly like the original. However, and this is potentially dangerous, the wiring is mislabeled. The diagram on the outside shows the use of wires 1, 3, 5, and 6. Open the cover to find wires 1, 2, 3, and 4.

Pros
  • Replacement oil and coolant pump for use with machines
Cons
  • Long delivery time

Revainrating 5 out of 5

Great replacement for our Mitsubishi pump at a fraction of the cost

We had an old Mitsubishi pump that failed on our Mazak CNC lathe. This was the same size and amperage as the Mitsubishi. It arrived the next day and we were back at work an hour after delivery and saved several hundred dollars. Would recommend.

Pros
  • Semi-open impeller for hard and fine debris
Cons
  • Available in black only

Revainrating 4 out of 5

Looks very well constructed. Used on my Acra 1340G lathe. Confusing wiring

This is a good pump, well built. Mine came wired for 110v. The wiring diagram sticker on the outside of the motor is confusing as the actual wires are labeled/numbered differently than the wire numbers on the pump body grommet (this is a good idea to follow when changing voltage settings). The wiring diagram on the outside of the pump matches the numbers (difficult to see visually) found on the molded rubber grommet where the wires protrude from the motor. Ignore the cable numbers on the actual

Pros
  • Sealless design for pumping abrasives
Cons
  • I won't say anything