Header banner
Revain logoHome Page
apdty 141615 intake manifold repair logo

APDTY 141615 Intake Manifold Repair Review

4

·

Poor

Revainrating 2.5 out of 5  
Rating 
2.5
🚀 Engines & Engine Parts, 🏎️ Performance Car Parts & Accessories

View on AmazonView on ЯM

Media

(4)
img 1 attached to APDTY 141615 Intake Manifold Repair
img 2 attached to APDTY 141615 Intake Manifold Repair
img 3 attached to APDTY 141615 Intake Manifold Repair
img 4 attached to APDTY 141615 Intake Manifold Repair

Description of APDTY 141615 Intake Manifold Repair

Brand New Technical Service Bulletin Repair Kit Includes:. 2 Knock Sensors & 1 Knock Sensor Wiring Harness, 1 Set of Intake Manifold Gaskets, 1 Tube of Silicone RTV Sealant (Permatex). Intake Manifold Mounting Bolts Sold Seperately; See APDTY 112685. Allows TSB 02-06-04-023A & 02-06-04-023 and/or DTC (Diagnostic Trouble Code) PO332 Repair. Replaces OEM 89060413, 89060413-TSB1, 89060413-TSB2, 17113697, 213-3521, 12601822, 10456603.

Reviews

Global ratings 4
  • 5
    0
  • 4
    1
  • 3
    1
  • 2
    1
  • 1
    1

Type of review

Revainrating 3 out of 5

Short cords on spares

Looks like a decent product until you can install it. The wiring was short. I had to use my original wiring. Everything else is fine. So be careful when removing the wiring as you will likely need it.

Pros
  • Pleasant to use
Cons
  • alt

Revainrating 4 out of 5

Will not fit 2007 Tahoe

I would appreciate Revain knowing that the 2007 Tahoe LTZ has knock sensors on the block and not under the galley. Come on, the intake manifold gaskets will fit as I removed the intake manifold for no reason.

Pros
  • New
Cons
  • Slightly torn

Revainrating 2 out of 5

The cable was too short and still got the code

On my 2005 Chevy Silverado. Replace the knock sensors, let all the water destroy the rear sensor. They look good overall, but the new design wires I got are too short and after the swap is complete I'm still getting a low knock sensor voltage code. The lines are well checked. The knock sensors must be defective or not working well with my truck.

Pros
  • Best
Cons
  • Packaging is ugly

Revainrating 1 out of 5

Trust the reviews. This set is junk!

Nonsense! Replaced the old one, clearly bad. With this set. The service engine light was cleaned with an obd2 scanner. Within 3 miles at 45-55 the service light came on again. Stopped with code reset and drove another 7 miles at 65-70 mph and the light came back with the same bank 2 knock p0332! JunkGot Spare Parts. I had to drill holes in the new/old ones to get them out. I drilled a hole to put a nail in because the inside was spinning while the outside was screwed into the motor. REPLACEMENT

Pros
  • Lots of positive emotions
Cons
  • No work