🔋 APDTY 150001 Jack Lift Point Pad Adapter: Protect your Tesla Model 3 Battery & Paint! Review

Whether you're buying a single vehicle or a kit, every Tesla owner should be able to jack their vehicle up if needed. I bought one and only used it to change my summer tires to winter tires. Because it has an O-ring, it stays in place while you install the jack. The only problem is I'm afraid to leave it there when I'm done.

I bought a set of 4. They arrived in perfect condition. I used them today 6/12/19 at my tire shop to change tires. They were easy to install and stayed in while he used 4 floor jacks to get the M3 turning. Once the job was done, the adapters could be easily removed and returned to their boxes for later use.

I bought these to jack up the car and paint the calipers. The product is strong, light weight and the 4 pack comes in a nice cylinder for easy storage in the car. So if you take the car to any garage (non-Tesla) or roadside assistance (non-Tesla) you can make sure the battery is not flat and you have the necessary converter. Necessary. It doesn't matter if you own a Model 3. Unless you just want to flood :)

For anyone doing it themselves, or even if you have a local shop that swaps summer tires for winter tires or fits aftermarket wheels, you simply have to having is raising your Model 3 safely. Otherwise, if the jack slips off the tin jacking points, which are very slippery, and hits the battery pack, goodbye Tesla, and hello, four-to-five figure repair bill. Not covered by your warranty. You're in a hole in the lift area (a very small area surrounded by lots of batteries!) which gives the jack…

Я взял 4 таких подкладки в Costco, чтобы поднять свою Tesla Model 3 для перестановки шин, и они не смогли их использовать, потому что подкладки слишком толстые, чтобы поместиться между подъемниками и Automobile. My local Tesla service technician told me that I don't need jack stands to raise my vehicle, but Costco and other garages would not lift my Tesla without jack legs due to liability issues. FYI these pads are 1 1/4" thick and have another 1/2" knob on top that fits into the hole under…

This jack adapter fits perfectly into the Model 3 jack sockets and fits in just the right amount, making it easy to install the jack under the vehicle once the adapter is installed is. Jacking up the car on a flat surface is very easy. Note that the adapter itself is fairly large (they all seem large) and the Model 3 (especially the high-spec variant) is fairly low, so you'll likely need access to a low-profile socket if you're using this Use jack point adapter and even then it fits right in…