🚐 High-quality White RV Marine Camper Vinyl Insert Trim Mold Screw Cover - 25 ft by Automotive Authority LLC Review

I made two stripes next to the front door. Took an hour. Looks a lot better. Bought black to hide mold and other blemishes.

I couldn't be happier. Arrived quickly and quickly installed on both sides of my caravan garage. Plus there will be plenty of extras in the future to replace one or both sides!

This guy is a little tricky to install, but with a flat blade - spatula and screwdriver - and a little patience your job will be beautiful when you're done. Do not use tools with shaped edges.

Ideal for the door upholstery of our caravan. Our old disguise was sun-bleached, wrinkled, and drained. An easy way to decorate your pendant! Installation is pretty easy, just press the "V" overlay and press on the channel. After a while, the fingers start to hurt, but in the end it's worth it. I posted a before and after picture to show the difference.

The surface of my RV is discolored and starting to fall apart. This finish made such an impression! Following another recommendation, I left it in the sun for about an hour, which made it softer and easier to handle. Also used a small spatula as a guide which saved my fingers. This length allowed me to replace the paneling around and under a full trundle bed and on all but the second 12" bed.

This molding was easy to install and much better. The way it attaches to the fairing and is covered keeps dirt and moisture out of the fairing area as it closes the fairing instead of the cheap plastic pads that attach to the fairing. It was very flexible and easily fitted around corners etc. A notice. Around my front door (24 inches) it had to be heated with a hair dryer for easy installation.

The plastic channel covers on my screen door ripped and finding a replacement was a test of patience. The channels were 1/2" wide and the width seemed close enough (0.62"). It worked great. I took another reviewer's suggestion and left it in the sun to soften. Came in like a charm. I just used a spatula and worked my way down. Since it's a bit wider than my canal, it's slightly arched. Being vinyl, I know it will shrink a bit in cold weather, so the fact that it's 0.62" would probably be a good

It took a year to find a good replacement for the lost panel around our RV door (it came off somewhere during an 8 hour drive). The dealer says this is a common problem, none of the parts were in stock. They offered to order some for 2.40 a foot! This replacement is about twice the thickness of the original (and less than half the price!). drive.Material looks high quality and flexible even at 50 degrees. It fits snugly in the groove and fits tight 4" radii on the corners of the door with no…

This screw cap is much better than the original product I had on my motorhome. The original was hard and brittle. Yes, it was old, but the design wasn't well thought out. This material is difficult to update if you have arthritis and do not have very good coordination. It's 1/16 wider than the gauge for a snug fit. This is good because it's flexible and bulges in the middle where the screw heads are. If it wasn't wider, the screws would push the skin out, the wind would pick it up, and it would