Header banner
Revain logoHome Page
autotoolhome titanium combination tapping 10 24nc logo

AUTOTOOLHOME Titanium Combination Tapping 10 24NC Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🪚 Industrial Drill Bits, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to AUTOTOOLHOME Titanium Combination Tapping 10 24NC
img 2 attached to AUTOTOOLHOME Titanium Combination Tapping 10 24NC
img 3 attached to AUTOTOOLHOME Titanium Combination Tapping 10 24NC
img 4 attached to AUTOTOOLHOME Titanium Combination Tapping 10 24NC

Description of AUTOTOOLHOME Titanium Combination Tapping 10 24NC

Titanium Combination Drill taps are made of HSS 4341, which can ensure sharp, fast execution and retain strength and efficiency. The surface is treated with a titanium alloy, which greatly improves the cutting performance of the drill, is more wear-resistant and prolongs the service life. Three in one operation provides hole drilling, tapping, deburring and countersinking for a quick and complete job on copper, brass, aluminum, sheet metal and plastic. This tap set includes SAE , so it has high versatility. Each tap drill is engraved with a label, which is convenient for you to choose the size that suits you. The convenient 1⁄4-inch (6.35mm) quick change hex shank has a tapered end to prevent excessive knocks. Back taper exceeds the tap to prevent over-drilling and damage to the thread. 6pcs drill tap set including SAE- 6-32nc, 8-32nc, 10-24nc, 10-32nc, 12-24nc, 1/4-20nc. Storage case is lightweight and durable for easy storage and is portable for all job environments.

Reviews

Global ratings 3
  • 5
    0
  • 4
    2
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

1 broke on first use

Unfortunately I broke the 1/4-20 on first use, luckily I don't need that size but still quite disappointing. I'm pretty sure it was defective because it broke before the tap part was screwed in, it was still on the drill. The rest was great. I mainly use them for control panels. Remember you cannot use them on materials thicker than the section of the drill.

Pros
  • Industrial & Scientific
Cons
  • Ugly packaging

Revainrating 4 out of 5

Great idea but be careful

I love being able to drill and cut the tap at the same time but it broke when I first used #6. But I'm not sure if it was a weakness of the tool, maybe it was my fault. Be careful with them as they are fragile. Use a light, low-power drill/driver to get a better feel for control and drill angle. The convenience of a drill and a tap in one tool is enough to justify the risk of one breaking from time to time. I will buy again.

Pros
  • Combined Drill and Tap
Cons
  • Drill Pack

Revainrating 3 out of 5

Mixed Results: Cutting Tools

1/4-20nc worked as expected. They were cheap, so I treated them carefully. Lots of drilling oil. I was able to easily cut sixteen holes with 1/4-20nc and it is in good enough condition to use again. However, I tried #10-24nc and it broke like a dry branch the first time I used it and got stuck in one piece. I haven't tried the others but I suspect they will be the same as #10. I can try a two step process of cutting through the material but not letting the overhang penetrate the part. Then I…

Pros
  • Taps
Cons
  • Expensive