🔪 AYAO Band Blade 2 Inch 8 Inch: Precision Cutting at its Best Review

If you're using a 59:1/2" saw, THIS is your blade! Cuts straight with no lateral movement and no welds. And you get two for your money.

I've had them for a few weeks now and they really are amazing! These blades just bite into wood, and not just pine, but hardwood as well.

Great product! Bought a Menards Nelson blade and only ran it for a few hours before replacing it with this one. Didn't know my mediocre skill bandsaw could cut so well. Great product and great price!

I took my 20 year old band saw blade and started cutting half a piece of 6061 aluminum. I took it slow but it went well. Haven't cut another piece yet but my first impression is that it's a pretty good blade.

These blades are great and cut very well. I have previously purchased Powertec 6tpi blades and they only smoked as they tore through the maple and were horribly pursued. Same specs as this Ayao blade and they cut the same hard maple as butter, follow well and leave a good (much better than the Powertec) edge finish after the cut. I will buy this again.

I mounted the blade on my 20 year old band saw and started cutting 1/2 piece aluminum 6061. I took it easy but it worked out fine. Haven't cut another piece yet but my first impression is that it's a pretty good blade.

These blades are great and cut very well. I have previously purchased Powertec 6tpi blades and they only smoked as they tore through the maple and were horribly pursued. Same performance as this Ayao blade and it cuts the same hard maple as butter, tracks well and leaves a good (much better than Powertec) edge finish after the cut. I will buy this again.

I have a 9 inch Skil saw. This is about the same entry level as band saws. It was my first saw so I had no reference and just worked with the standard blade and the Bosch saw blade I replaced it with. The cuts have always been disappointing, massive curve and very rough cuts. I installed this blade and made my first attempt on a 2 inch piece of cherry. He cut through it the same way I cut through the 1/2 inch layer with the previous blades. The curvature is minimal and the cut is much cleaner…