Header banner
Revain logoHome Page
baytory 60 degree countersink metalworking positioning logo

BAYTORY 60 Degree Countersink Metalworking Positioning Review

2

·

Poor

Revainrating 2.5 out of 5  
Rating 
2.3
🪚 Industrial Drill Bits, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to BAYTORY 60 Degree Countersink Metalworking Positioning
img 2 attached to BAYTORY 60 Degree Countersink Metalworking Positioning
img 3 attached to BAYTORY 60 Degree Countersink Metalworking Positioning
img 4 attached to BAYTORY 60 Degree Countersink Metalworking Positioning

Description of BAYTORY 60 Degree Countersink Metalworking Positioning

[Precise positioning] HSS A type center drill is very useful in drilling accurate center holes, 60-degree chamfer can complete the dot hole at one time. [Good Chip Removal] Spiral groove helps clear chips and debris away from the bit, conducive to high-speed operation, accelerated chip removal, high temperature resistance and no sticking to the knife. [High Quality] Using high-speed steel material full grinding process, with high hardness and high wear resistance, can process high-hardness materials. [Sharp Edge] The Titanium drill bit is very wear-resistant, high processing efficiency and long service life. [Widely Applicable] work with lathe machines and most electronic drills to drill holes in Steel, Iron, aluminum alloy, Carbon Steel, Brass and other tough material ranging.

Reviews

Global ratings 2
  • 5
    0
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Stressful Experience with Inaccurate Countersink

This Industrial and Scientific countersink was a source of frustration for me. I relied on its claimed accuracy for a project but it failed to live up to expectations. The design of the tool made it difficult to use and it ultimately compromised my work .On the plus side, it seems to be made from durable materials. Unfortunately, the cons definitely outweigh the pros in my experience..

Pros
  • Allows for precise countersinking at a 60-degree angle
Cons
  • May require some skill or experience to use effectively

Revainrating 3 out of 5

The bits are fine but

The case will likely break as it's not big enough to hold the two largest bits and they get stuck in the side of the loop so the loop eventually breaks. Plan to save them in other ways.

Cons
  • crumpled