Beadsmith MCR01 Micro Engraver Review

Unfortunately, this engraver worked a total of less than five minutes before stopping completely. Changing batteries (five different sets) didn't get it working again. He's dead. In the five minutes it actually worked, the engraver did a pretty good job of engraving the metal pendant, but I wasn't impressed with the quality of the engraving. It was certainly an expensive item considering how much a minute of use cost.

Poorly made and cheaply made tool. The switch is broken and only works 1 time out of 5, and even then it only works for 2-3 seconds. Sometimes the switch works if you shake everything, but only a few times. Either the battery contact is bad or the switch itself is of poor quality. The rest of the tool is of similar poor/cheap quality (poor plastic moldings, faint and uneven BeadSmith logo, loose connections in the battery compartment, uneven molding where the bit is placed). inserted). Even for

I have a network engraver, but the cable makes it difficult to use. I love this little engraver because it's as easy to use as a thick pen. My electric model is like a little jackhammer. He replies. This little tool rotates and engraves just like the Dremel Moto Tool. But the small size, light weight and lack of cords make it so handy for engraving. It took me very little time to engrave my MAGLITE S4D016 Heavy-Duty 4-D Cell flashlight just above the on/off switch. It did a very good job. On a…