Header banner
Revain logoHome Page
πŸ” enhanced seo: beckarnley 016-1075 premium cylinder head bolt set logo

πŸ” Enhanced SEO: BECKARNLEY 016-1075 Premium Cylinder Head Bolt Set Review

4

Β·

Very good

Revainrating 4.5 out of 5Β Β 
RatingΒ 
4.5
πŸš€ Engines & Engine Parts, 🏎️ Performance Car Parts & Accessories

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ” Enhanced SEO: BECKARNLEY 016-1075 Premium Cylinder Head Bolt Set
img 2 attached to πŸ” Enhanced SEO: BECKARNLEY 016-1075 Premium Cylinder Head Bolt Set
img 3 attached to πŸ” Enhanced SEO: BECKARNLEY 016-1075 Premium Cylinder Head Bolt Set
img 4 attached to πŸ” Enhanced SEO: BECKARNLEY 016-1075 Premium Cylinder Head Bolt Set

Description of πŸ” Enhanced SEO: BECKARNLEY 016-1075 Premium Cylinder Head Bolt Set

Matches OE form, fit, and function. Calibrated to factory specified yield point. Quality construction for durability. Premium construction for durability. Application specific to ensure a correct fit for your vehicle.

Reviews

Global ratings 4
  • 5
    2
  • 4
    2
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Please order triangular hex head

These screws work now. Everything seems fine. You will need a different hex head as stated in another review so order right away and you're done!

Pros
  • Premium design for durability
Cons
  • Reliability

Revainrating 5 out of 5

Perfect replacement for my 2010 Toyota Prius 1

Perfect replacement for my 2010 Toyota Prius 1.8 liter engine. I had to buy a 12mm hex to take the old one out and put the new one in. The 12mm double hex socket was only available from Auto Zone in my area, not other dealerships.

Pros
  • Quality construction for durability
Cons
  • Some faults

Revainrating 4 out of 5

Uses M12 XZN Triple Square Drive Bit

When replacing head bolts on a Toyota engine you will need a 10mm double hex bit (blue chart) to remove the head bolts. Perhaps an M12 XZN Triple Square Bit (red diagram) would also work. These Beck/Arnley cap screws are made in Spain and use an M12 XZN triple square drive bit. You cannot use 10mm double hex sockets to install these Beck/Arnely head screws.

Pros
  • Calibrated to Factory Specified Yield Strength
Cons
  • Functionality

Revainrating 4 out of 5

2010 Prius: Fits, but you need a completely different key!

To remove the OEM cap screws on the 3rd generation Prius you will need a 10mm double hex bit. To install Beck-Arnley bolts you will need a 12mm triangular bit as the double hex will not fit these bolts at all. This fact is not mentioned in the description (or on the manufacturer's website), hence the 3 stars. Also, the bolts fit perfectly on my 2010 Prius engine.

Pros
  • Same as Original Equipment form, fit and function
Cons
  • So far so good