🚙 Authentic Black Dodge Ram OEM Front & Rear Ram Head Emblem Medallion - 1500, 2500, 3500 (Mopar) Review

Looks Great, Fits Perfectly. Easier to install than the instructions say. The front grille does not need to be removed. There's plenty of room to reach and push through the tabs. Use a piece of fishing line and you can remove both emblems in less than 10 minutes.

Badge on tailgate fitted easily and looks good. The front emblem clips did not fit well and would not snap into place like the original and eventually broke. I was able to reassemble it and work with the extra 3M tape. I'm not sure if that's really part of MOPAR. The quality isn't as good as the chrome I removed.

Looks great on my black truck! Almost exactly like the factory emblem, only black. Fairly easy to install, had to unscrew the top of the grille to pull it forward so I could detach the original badge and then this snapped into place. Attached photo: Left original factory emblem, right all black replacement.

They just look cheap. My original emblems were aluminum and these are plastic. Now I can't say for sure if the factory black emblems aren't plastic, but they just look cheap to me. I'll try to paint them matte so they don't look like plastic. I'm just skeptical that this is an OEM based on my old emblems after removing them and comparing the two.

Well I liked the look but when I decided to put the rear emblem on it didn't fit. One of the pins was too big on the wrong side, I didn't realize it until the back came loose and half the pins got stuck. Looks like it's true to size but a bit big. Now I have an emblem that isn't fully applied and I can't remove it or I don't have an emblem. Not too happy about that.

Can't help but leave negative feedback. I will say they look good because they are not OEM. The one on the back door seems fine. The front is the problem. One of the clips broke immediately. When I took it off, it broke into 2 pieces. I was able to glue it back together but not sure how long it will last. A bit disappointed but then again they were cheap. I'll look at the OEM front to replace once it fails again.

Arrived slightly damaged but excellent quality paint and scratches polished with polishing paste. For the front emblem you will need to use a soft plastic removal tool. Also, carry adhesive remover or scratch remover to remove the remaining adhesive of the factory emblem. The overall quality I give them is 9.5/10 due to the scratch. I'm glad they're actually painted gloss black and not mere plastic and won't fade in the sun.

Owner of the 4th The tape is total junk. I removed the old badge with an eraser, washed the truck, and rubbed rubbing alcohol over the area where the tape should have been. Did it this Saturday. It's Tuesday and the only thing holding it up is a giant clip! The badges are good quality so if you plan on getting them save yourself the hassle and order 3M tape as well.