🔩 Bolt Mc Hardware Aluminum Thread Chasers for M6/M8 Threads - TC-M6M8 Review

Took these to clean the threads of some LS manifold bolts. As a result, I bought a full set of metric and standard. A good product.

Amazing I've had a hard time installing headers on my Cobra engine. The screws fought against me at every step when I stopped what I was doing before damaging anything I ordered these and like Jesus himself cleaned the threads the oil is slick

I figured I'd need a machine shop or even a new wheel after squeezing a bolt into a hardened threadlocker. I googled a bit and found the concept of filament tracking. At first I was going to buy a set of taps and dies, but instead I found this product. So happy I did.

Stuck internal threads in the door of my Porsche 996. Saved me a headache. strands, a quarter turn, then step back, then a quarter turn, then step back, slowly further and further into the hole. Take your time. It works, and you're less likely to damage it than you would with a full jab.

Bought Lang's range and also ordered as they're only $10, maybe keep in your tool bag. Hunter Lang worked well and seemed to connect more. After running Lang instead, the bolt came out fine, and yet after comparison it still sticks. I won't force it as the latch works after the lang. Instead, I would recommend Lang and not worry.

THE FIRST TIME: WOW! These guys/girls helped me a lot. Expedited shipping was a bit high for them but I ordered on Saturday night and they were at my door on Tuesday. Great! 2nd: It worked exactly as described. The screw holes in the valve cover were clogged and the threads torn off. I dipped this little rooster in oil, put it in the threads, pulled a hair off to put in the threads, then threaded it through each hole. Now my new bolts cut through butter like a hot knife. THANK YOU LONGHORN…