📏 Camco 25583 AccuLevel Brackets: Achieve Perfect Leveling with Ease Review

these were supposed to come with AccuLevel (we're talking stamped metal and a couple of screws), they have not been sold separately since, but they worked as intended

These brackets go well with my spirit level. Even though it was a different brand, it still fit well. Good strong metal braces should last a long time. Delivered on time.

After reading all the negative comments about broken screws I decided to drill and tap holes before using the mounting screws. Took a little longer, but worked great. screws and 1/4-20. The drill size is still 7/32.

Probably a good mount but my pen box is too flat on top so I can't use the mounting holes. I'll make a clamp to lift it higher. If you have a box with a steeper angle it will probably work just fine.

I ordered these mounts with AccuLevel to fit my MorRyde contact box. All necessary hardware is included and only four 7/32 holes need to be drilled in the pen box. Installation took about 15 minutes. Slotted holes allow for front-to-back and side-to-side height adjustment when AccuLevel is installed. I consider this a necessary item to install AccuLevel for 5 wheel trailers.

This bracket is needed to install the Acculevel on the pin box for the 5 wheel trailer. The instructions say to pre-drill the holes with a 7/32 bit. This is too little. I had to go down to size .206". Then the self tapping screws included in the kit are not self tapping screws. They are also very soft. I had two turns before they were fully screwed in. Now you have to go to the hardware store and get a better quality screw buy. Maybe they would have worked if I had chosen a bigger bat. Maybe…

Just mount this on my fifth wheel. It took longer than I thought because I ran into a small problem. The instructions say to drill a 7/32" hole and use the included self-tapping screws. Well as another review says these bolts are soft and I broke one. First, the metal that makes up the hitch is hard and thick. I found it difficult to drill holes. When I put a screw in, it twisted as soon as it hit the ground. I had to drill out that bolt and put a smaller bolt and nut on the inside of the…