🏍️ Yamaha Bear Tracker YFM250X/YFM250XH/YFM250B Carburetor Manifold with Air Filter - Carbhub Beartracker Auto Moto 1999-2004 Review

The carburettor arrived quickly and was well packaged. Installation was easy. The engine started immediately, but did not accelerate. I removed the carburetor and replaced the injectors from the original carburetor, I unscrewed the mixture screw 3 1/2 turns. It now runs like new and passed the road test perfectly. Small improvements on the old car. I would again.

Plugged in and still having problems. The weird thing is that it worked better with the airbox off. Took it to our local shop as we couldn't figure out what was going on and felt the jet it was delivered on was too big. It replaced a jet and a few days later we took it on a 60 mile trip and it worked like new!

carburetor used. It smelled of petrol and was dirty. Cleaned it out and installed it to see if it worked as we needed a car for the trip. It didn't work properly. It worked smoothly but stalled when driving or increasing speed. All other things were great. Very disappointed and one bike wasn't enough for the weekend trip.

My four-wheeler has never worked better. This carburetor was easy to install and was exactly the same as the original so everything fitted perfectly. The delivery was fast and I am very satisfied. This is my first purchase from this store but I'm sure they will be my first choice from now on, they ship quickly and I've had no problems.

Scrap. Got what we paid for. Not quite. We spent $50 and didn't get a working carb. We had a wasted weekend putting the old carb back on the quad because that junk had pin problems. The same problem has already been mentioned by many other buyers. Needless to say, not checking reviews up front costs money and time.

I read other reviews so before installing the carburetor I swapped out the injectors for the factory ones. other thread but I don't know if the carburetor was different or if my new jet was wrong so I left it. The needle clamp stayed as it was, in the lowest position. Started immediately with no choke. Worked fine until it warmed up so I could adjust the idle mixture and RPM. Since then I have been very impressed with his work. I used to think my BT had low compression, but now it runs harder…

Works great but not with stock Bearcat airbox. I spent several hours fiddling with the primary jet to keep it from choking. Could never get it right. The problem was that it worked fine, but when you added power it started crackling and almost died. The final solution was to remove the entire air intake including the snorkel hoses and boxes. and place the air filter directly on the back of the carburetor. Now he walks like a raped monkey. The only problem is that it can't go through much water.