Century Drill Tool 92910 Rethreading Review

I can't put into words how good this little tool is! This saved me $220 and a lot of work! The spindles on my Ford E350 RV broke because I was going insane over tightening the nuts after some really bad advice from neighbors. I wanted to replace both with used ones for $150 a side, plus $70 for a new set of King Pings. The attached photo shows the right side before and after. The left side was worse, but the reaming nozzle fixed it too. The new spindle nuts thread well, don't wobble in the…

The photos match the item I received. They must have been updated after reading the negative reviews. This tool worked great for deleting threads in my project. It's a good weight and appears to be made of quality metal. Much better than the stamps in my cheap Chinese port set. I bang the ends of the stainless steel threaded rod on the power tilt and trim tab on my 1978 Chrysler outboard with a large hammer. I flattened the end of the rod. She erased that matrix straight away. One side of the…

Worked great for cleaning rusty threads on a Laycock-DeNormanville Compact A-Type Overdrive Output Shaft that has been outdoors and exposed to the elements. The cotter pin was completely rusted so I had to break it and use a percussion tool to remove the castle nut which could be removed by hand once loosened. Needless to say, the threads were a rusty, damaged mess. The output shaft on them is part of the annulus and is difficult to replace and hard to find. I'd be pretty shocked if this matrix