Amazicha Chrome 4 Point Docking Hardware Kit for Harley Road King Street Glide, 2014-2021 Review

This is a high-quality alternative to HD spare parts. Easy installation although the washers provided do not fit/work. Installed on a 2014 Harley-Davidson Ultra Limited (FLHTK)

The chrome finish is good! I had to buy smaller washers before the included mounting bolts, they were large in diameter. I bought these to use an old travel tip pack.

This is the perfect solution for expensive HD Factory products. On my bike it went easily in less than 20 minutes. Easy DIY for 1 person. As for the quality? All parts appeared to be made of quality metal, but only time will tell. If you are looking for a cheaper alternative then this is it. It fits the 2021 Street Glide Special.

Good alternative to more expensive Harley Davidson docking stations. High quality. Ease of installation. Most reviews state that the washers that come with them are too big. In fact, they don't fit on the outside. However, if you carefully place them outside of the docking gear but inside the frame, they work great and provide wider coverage of the docking gear as intended.

Replacing broken Harley gear for a fraction of the cost makes me very happy! Unfortunately I didn't get around to using Loctite (because the OEM hardware was one piece I didn't realize I needed it) and I lost a small part somewhere on my first trip. I hope that the seller will offer to sell me the missing part. (Will be upgraded to 5 stars if customer service does a good job)

I always worry when I order parts that are significantly cheaper than OEM. These didn't disappoint at all! The fit and finish is excellent and looks the same as the HD variant. Installation took less than 5 minutes, but I caution you not to over-tighten the screws. I would probably recommend a bit of thread lock rather than too much torque. Honestly I can't believe how good they are for the price. I definitely recommend them!

Looks good but when you assemble it you will find that the 4 screws that support the weight of the docking system are small and unreliable. Also, the holes for these screws are drilled in soft plastic. Stripped 2 out of 4 for me. I made sure all the screws are secured with a lock. After just a 30 minute ride out of town, I almost fell off my bike with my travel backpack. Went with Harley 4 point docking system. MUCH BETTER.

I bought these at my local HD dealership as an alternative to the $180 set. They came pre-assembled so all I had to do was remove the inserts and throw them away. I installed them in 5 minutes including removing the pockets and re-attaching. It took me longer to put away my tools than to install them! The only issue I had, hence 4 stars instead of 5, was that the screws provided could not be used as the washers were too big for the cut out in the rack cover. I reused the hanger bolts, which are

I checked the rubber bushing screws and found that each bracket had at least one screw that was loose. I tried removing the screws to apply the Loctite, one came out easily and the other took some effort. Normally this wouldn't be a problem, other than there being no way to keep the round button heads on the insert that the screw threads into. No matter how I tried to hold the insert (taping the surface with electrical tape and holding the round head with a rag and pliers), I couldn't help but…