Header banner
Revain logoHome Page

Reviews

Global ratings 44
  • 5
    33
  • 4
    6
  • 3
    1
  • 2
    2
  • 1
    2

Type of review

Revainrating 4 out of 5

The product did not disappoint, the quality pleases.

I worked with a disk for the first time in my life, my impressions were positive, I cut a furniture board (planked) like butter and, in principle, evenly (hands are crooked (well, I didn’t saw it before), in short, the necessary addition to the jigsaw. We need a vacuum cleaner, it flies much less (at times). The disk that is included for floorboards and beams, sawing laminate and thin beautiful things will not work, you have to buy another disk.

Pros
  • As usual: Bosch. Enough for now.
Cons
  • During 5 minutes of work on the board, a hexagon was found attached to the case (fell out by itself) or not stored there or it could fall under the disk (if careless) and then . There is no lock for the protective cover. The attachment of the vacuum cleaner does not hold well - it flies off (and it is necessary).

Revainrating 4 out of 5

Good product for me, I was satisfied with the price.

When unpacking and inspecting the saw, it immediately caught my eye that the disc was not perpendicular to the sole. I checked with a square - it was confirmed - about 2.5-3 degrees. A trifle, but, as they say, not pleasant. I hoped that the sole is not deployed to 0 °. No - all the way. The adjusting screw helped - I had to unscrew it almost completely so that the sole would stand at 0 ° and the angle between it and the disk would become 90 °. Also, with the front lamb fixed, I had to apply a…

Pros
  • The build quality is quite good. When turned on, there is no strong jerk, despite the lack of a soft start. Long cord. Parallel emphasis sits tightly, without backlash. The presence of a scale for the depth of cut. But, one of the main reasons why the choice fell on this particular model is that the cutting depth at 45 ° is 50 mm, and this is with a 190 mm disc.
Cons
  • Coarse, inaccurate factory setting of the sole position for 0°. The disc was not perpendicular to the sole (see comment). I would like to see the sole itself cast, not stamped. Although, maybe this is precisely the advantage of a few millimeters difference between stamping and casting, which allow you to have a cutting depth of 50 mm at 45 °.

Revainrating 5 out of 5

The quality is at the level, I am satisfied with everything.

Has some pros: Good saw, honest 70 mm cut, comfortable to hold, cuts cleanly. Good ruler limiter, not a curve. With its cons: The cut depth ruler must be marked by yourself, the factory risks do not match the actual depth. I made my marks, now the accuracy is 100%.