CNCMOTOK Folding Aluminum Handlebar Motorcycle Review

Modifications made to fit the disc brake master cylinder, looks like the lever ratio is wrong, not that much cable length, nevertheless they work with some polish and finesse.

Comes well packaged and as described Fits both left and right handlebars that fit standard 7/8" off-road motorcycle handlebars. Installed to my noise and was able to install them next to my remaining switches with no problems.

Replacement was easy. This is an exact match for the Apollo 125. I put the bike into a turn (sandy mud) and the lever clicked at the turn point. If you don't plan on destroying, this lever is what you're looking for, but who's going to destroy anyway? I would go for the best branded lever if you are racing or jumping.

on the first press to pump fluid into the caliper. The brake lever WILL BREAK! This is unacceptable and DANGEROUS as it is CLUTCH and BRAKES! I would never skimp on brake and clutch levers! They are one of the most important safety features on any powered machine. You get what you pay for here!

Clutch side lever snap snapped while adjusting cable tension. Luckily the stock lever uses the same perch so I was able to use the stock lever. The brake lever didn't fit either, it was a bit thick for a perch, after some filing I managed to get it working. Think of the burrs where they were cut, they weren't clean at all. I used a small file to remove the burrs to avoid damaging the clutch cable. Bike SSR 110. You get what you pay for.