🖨️ Creality Separate Package 3D Printer Review

Works great, just what I needed. When I first assembled my Ender 3 the metal clip for one of my axles fell off so I had trouble with the head just cutting into the side of the printer until the stop button was activated. I bought these, unscrewed/disconnected the broken stop and put this in place. Worked great and now I have 2 extras if I ever need them!

This was an almost imperceptible replacement, but I had to drill mounting holes to mount the plastic mounting block to my Ender 3 Pro. Just had to enlarge the holes by 0.8mm (1/32 inch). Before I did that, I couldn't get standard printer screws or socket head screws to get past the electrical connector. However, I would buy them again.

Turns out I had a faulty Z limit switch on my Ender 3v2, hence the auto reset went off the nozzle, and limit switch pressed do not always snap into place/pressure. So much so, that sometimes I could hear the switch *click*, and sometimes it wouldn't even shut down. This means that I leveled the platform to a height and then when I started printing and it automatically returned to its original position before I started extruding, the nozzle was higher or lower than what I just leveled would…