🚚 Dasen Below Cargo Bed 27W LED Light Bar Kit for Polaris Ranger Crew 1000 XP - Easy Plug N Play Installation with Back-up Brackets - No Drill Required (2018-2021 Compatible) Review

Very easy to install in less than 10 minutes just plugging it into the pre-wired connector and the super bright light is easy to see when reversing at night

Took 5 minutes to install and works great which comes in handy when you need to tie down your car after dark. Particular care is only required when connecting to the trailer after assembly.

2018 Polaris Ranger 1000 bracket will NOT fit mine, motor mount bolt is too long when attaching bracket to headlight where longer is great! play very bright Lights up during operation and a few minutes after the car has been switched off (very dim, not bad) Works great when in reverse

Purchased in November 2019 and now completely unusable as wet LEDs are dead. This element began to fail after the first year, and now there are so many dead that it is completely useless. Dissatisfied with the durability of the product. I don't recommend this for people who need a reliable backup light.

Great product and easy to install. I have a 2019 Ranger XP 1000 NorthStar and was able to mount it on the left side of the stabilizer bracket. The bolt and nut protruding from the bracket were enough to add the light bracket without removing anything. Plugged it in and it worked with the existing wiring/plug and transmission sensor, no switch needed in the cab. And the light is far enough away from the muffler that heat isn't a problem.

Installed the reverse light on my 2019 Polaris Ranger XP1000 and the light works great and easy to install. The light is plug and play and very bright and I recommend this light. The only problem is that it stays on (but very weak) for 2 minutes after turning off the engine. It doesn't bother me because after I turn off the engine it's very dark and it goes off, but not immediately. This is not a problem for me. I'm glad I bought the lamp.

Fits a 2020 Polaris Ranger 1000 Crew Premium (not XP). There is a small pre-drilled hole in one of the crossbars just above the muffler. You'll need to drill a little more to get through the included screw. Installs in less than 5 minutes, plugs into an existing blue plug under the bed. This connector is unused and has a cap that must be removed. When the Ranger is on, a faint glow appears in the lights. Illuminates the world when you put it in reverse.

It says it doesn't work on Northstar and can't be mounted in the location specified in the instructions. I just installed mine by drilling a new hole on the bed hinge. The light stays on a little bit all the time when the key is on and stays on for about 2 minutes after the key is off, this is not a big deal and is down to the computer program. Put the ranger in reverse and the light gets very bright. Seems to be of very good quality. updated 15.09. I was fine while it lasted, only noticed that

Okay I was so skeptical about this product that I now wish I had bought this backup light a year ago when I bought my ranger. I installed this on a 2019 Polaris Ranger 1000 XP Premium. Installation was super EASY! It works as described, believe it or not! It's freaking awesome! It is very bright and only lights up when reversing. Feel free to buy this product! five minutes of installation and you will regret not buying this reversing light for a long time, just like me! If you have a ranger…