Daystar 0.75" Lift Kit for Jeep ZJ Grand Cherokee - Fits ZJ and TJ Models from 1993 to 2006 - 2/4WD - All Transmissions - KJ09108BK - Made in America - Black Review

Used them on my 1998 Jeep Grand Cherokee to get a little more 4 inch lift. They fit perfectly in the front. I had to trim them to fit the back and the center hole was too big. Still works, but not quite right for the back.

Easy to fit on a 2001 Jeep TJ. Offers 3/4" (+/-1/16") front and rear. Easy installation, but buy replacement fenders if you've never replaced the stock fenders. You have to remove them to get the spring out and they will fall apart.

Kit includes front and rear spacers. Only 4 spacers, I only needed the front ones. This is exactly what I needed to level the jeep after the 2 inch pro comp lift. It is 1.25" when combined with a 0.5" OEM coil rubber isolator. It bolts seamlessly to the factory mount and mates perfectly with the OE rubber isolator. Highly recommended if your TJ has a rake forward after the lift, although YMMV depends on lift height.

Previously installed a 1-3/4" FRONT Lifter from Daystar on my Wrangler TJ 02 which took about 4 hours. Loosen the tabs then jack up the rear of the Jeeps on and then place the frame securely on jackstands, remove the wheel and then fully lower the rear suspension (deep head or short extension) Note: The bumper and bumper cover are now seated in the spring, now just raise the rear end on the shock to compress the use a spring compression tool (I used a ratchet) to hold the spring in place and…