🔧 MTC 20224 / GX20053 Steering Gear Pinion: Perfect for Special Models Review

Like other reviewers said it should be soft metal. Good value if you don't mind putting in a new set of gears every six months.

Worked fine on my la175. I recommend replacing the steering plate that meshes with this gear at the same time as they will wear out each other.

This one was used on the L130 - as other reviews have said it fits very well. Based on someone else's suggestion, I used a small file to ensure the leading edges were smooth. then "forced” the gear onto the shaft by tapping it with a hammer. As soon as it started it went straight up and according to the same reviewer I used the old gear when I put the new one in - and it was perfect. I didn't need a puller or anything to remove the old gear. brian

The MTC part is not the same as the John Deere GX20053 part. This was a close attempt to reproduce the original, but aftermarket parts (even after using a file to enlarge the holes) should not require a hammer to install. Sitting under a lawnmower really isn't something you want to do. Your design is simply flawed. Worse still, I tried to remove the part so the new John Deere part I ordered could easily snap into place. While you can hammer in the MTC parts, the JD parts just work. My…

This gear was an exact replacement for my old worn one. The only issues I had during the DIY repair weren't the fault of the seller or the manufacturer of that part, but I want to describe it here for anyone who thinks they can "just unscrew the nut and replace this part". ". You will need: 1. 3/4" socket (preferably 1/2" drive) with breaker2. Gear Puller - I had a puller with a connecting rod and was able to get it to work.3. PB Blast or WD-404. stand5. Small metal file 6. BFH (Big F'n Hammer)